Type: Embossed wall cladding
Price: Corresponds to 1 square meter (4 boards measuring 50cm x 50cm each)
Fixing: Contact glue
Installation location: indoor environment protected from sun exposure and rain
Brand: FORMIX 3D
Raw material: PSAI – High Impact Polystyrene
Additional product information:
The 3d plates are made of plastic material, known as polystyrene, an extremely resistant and durable material.
Suitable for use in homes, shops, shops or offices
To perform the installation, follow the steps below:
1 – The plates must be fixed next to each other using contact glue.
2 – Observe if the wall has lumps, holes or large depressions that could jeopardize the quality of the installation of the plates.
3 – Clean the wall with a damp cloth to remove impurities, dirt and dust, as this could impair the quality of the collage.
4 – Draw a grid around the entire wall with 1 pencil and a ruler, making squares the size of the board. Note that by tracing the wall, you will already define the cut pieces on the side (if there are cuts).
5 – The installation should start from the side without cutouts.
6 – Use contact glue to fix the plates, applying evenly on the wall using a brush, and then on the back of the 3d plate. Important: spread the glue well so that there are no excesses and always follow the guidelines of the glue manufacturer. Too much contact glue can damage the board.
7 – After fixing all the boards, apply PVA spackle to the seams and in external environments, use acrylic spackle, cleaning immediately afterwards any excess spackle, avoiding the need for sanding.
8 – The installation will be completed after fixing the last board and grouting all the seams.